Owning one · troubleshooting
Which bow thruster do I have? Find the maker and the model
You cannot price a part, read a fault code or order the right anode until you know the maker and the model. The answer is on the boat, in one of five places, and most owners find it in the first two.
For your own boat: the Thruster Finder asks seven to nine questions and lists what fits her, priced installed; the size calculator gives her thrust figure from her length and kind; the quote checker says where a yard’s number sits against what owners paid. The compare page puts every model in one table, sorted or side by side.
- No tools, no haul-out
- Five minutes with a torch
- Switch the battery main off first
- Places to look 5 › The motor label settles it on most boats.
- Where the motor is Forward › A tunnel unit’s motor sits inside the hull above the tube, in the forward locker or under the V-berth.
- Makers on this site 9 › Every model sold in the US, current and discontinued.
- Models on file 230 › Plus 33 discontinued models with their own pages.
- Only a code, no name? The letters › Most makers’ codes open with letters that name them.
- Found it? Parts finder › Type the model or a part number and the page comes up.
Five places, in the order to try them
- The label on the motor. Maker, model and serial number, on a plate or sticker on the motor housing. More
- The control panel or joystick. The maker’s name is usually printed on it. Panels and motors are sold as one system. More
- The main fuse and the cable. The fuse rating and the cable size narrow the model once you know the maker. More
- The boat’s papers. The sale listing, the survey, the yard invoice or a manual left aboard. More
- The unit itself. A tunnel, a bracket on the hull or transom, or a leg that drops out of the hull each point to different makers. More
Write down everything on the label, a photo is better, before you go looking for a part. A maker’s part number depends on the model and often on the voltage, and the serial number tells the maker which year’s version you have.
The label on the motor
Every maker puts a plate or a sticker on the motor housing with the maker’s name, the model and a serial number. Finding the motor is the job.
A tunnel thruster. The motor sits inside the hull, directly above the A tube bored straight through the hull below the waterline, with a propeller in the middle of it. It is the conventional thruster. Installing one is mostly a labor job rather than a hardware one., as far forward as the boat allows. Look in the anchor locker, the forward cabin’s under-berth lockers or a hatch in the V-berth sole. It is a cylinder the size of a large coffee can or bigger, with two heavy cables on it.
A retractable. The motor and the leg sit in a box inside the hull near the bow, under a hatch or a berth. The label is on the motor, at the top of the box.
An external unit. The unit is outside the boat, on a bracket on the hull or the The flat surface across the very back of the boat., or on a track it rides up and down. Its label is on the unit itself, and on some the maker’s name is molded into the housing.
A stern thruster. A tunnel at the stern puts the motor in the lazarette or under the aft berth, above the tube. An external stern unit is on the transom.
Older labels fade and some are painted over. If the words are gone, the shape of the plate and the color of the motor still help: take a photo and compare it with the pictures on the maker reviews.
The control panel or joystick
The panel at the helm almost always carries the maker’s name, because panels and motors are sold together as one system. A name on the panel is the maker of the thruster on nearly every boat.
The exception is a boat that has had work done. A replaced panel from another maker is rare, because the wiring between panel and motor is each maker’s own, but it happens. If the panel’s name and the motor’s label disagree, the motor is the thruster.
While you are at the helm, note what the panel does when you switch it on: a light, a tone, a display. The light and beep codes are filed by maker, and the panel’s own behavior often narrows it further.
The main fuse and the cable
Near the battery that feeds the thruster sits a large fuse, and from it two heavy cables run forward. The fuse’s rating is printed on it, and the cable’s size is printed along its jacket.
Neither names the maker on its own. Once you have the maker from the label or the panel, though, the rating narrows the model: each maker’s manual calls for one fuse per model and voltage, and the wiring calculator lists them. A 12 volt unit and a 24 volt unit of the same model carry different fuses, so the fuse also tells you the voltage.
The boat’s papers
If the boat came with a survey, the thruster is usually named in it. The sale listing often names it too, and a previous owner’s yard invoices name it exactly, down to the part numbers. A manual left in the chart table is the best find of all: it names the model and tells you the codes.
If nothing aboard names it, email the maker a photo of the unit and the panel. Every maker review on this site says who sells and supports that maker in the US.
What the unit itself tells you
Before you find a label, the kind of unit already rules makers in and out.
- A hole through the bow with a propeller in it. A tunnel thruster. Most makers sell them, so the tunnel alone does not name one.
- A hatch in the hull near the bow that a leg drops out of. A retractable. Fewer makers sell these.
- A unit on a bracket on the hull or the transom, or on a track. An external unit. The types page shows each maker’s version.
- A motor with no battery cables of its own, lifted on a rope. A unit that carries its own battery and rides a track. The no-hole page covers it.
Only a model code? The letters name the maker
Most makers’ codes open with letters that belong to that maker. This table is read from the 263 models on this site, current and discontinued: the letters that open two or more of each maker’s codes.
| Maker | The code usually opens with | Models on file |
|---|---|---|
| Sleipner | SE, SEP, E, SX, ERV, SRV, SRVP, SAC, SXP, SRL, SRLP, EX, ERL, SR, SRHP, SRP | 111 |
| VETUS | BOW, STE | 49 |
| Max Power | CT, ECO, VIP | 40 |
| Lewmar | Numbers, or names: no shared letters | 24 |
| Sideshift | OB, SD, SS, HB, PT, ST | 18 |
| Quick | BTQ, BTR | 10 |
| ezDrive | Numbers, or names: no shared letters | 4 |
| DockStar | SMART | 4 |
| Yacht Thruster | Numbers, or names: no shared letters | 3 |
Letters the database holds for two or more of a maker’s models. A code that opens differently can still be that maker’s: type it into the parts finder, which searches every model and part number on the site.
Found it? Where it takes you
- The model’s own page. Its specs, the boats it fits, and every part with a US dealer number and price. Every model, by maker
- Its fault codes. Each maker’s lights and beeps, in one place, folded by maker. Light and beep codes
- What a repair costs. Each job priced from the parts file, and whether the boat comes out. Repair costs